This Vibration Sensor use the SW-18010P from MEC to measure the vibration.It can triggerd from any angle, and often used for flex, touch, vibration and shock measurements.
There is an on-board potentiometer to adjust the threshold of vibration.It outputs logic HIGH when this module not triggered while logic Low when triggered.
Application Idea
- Automobie alarm.
- Movement detection.
- Vibration detecting Applications
Features
- The default state of the switch is open
- Digital output
- Supply voltage:3.3V-5V
- On-board indicator LED to show the results
- On-board LM393 chip
- Dimension: 3.2cm x 1.4cm
SW-18010P Vibration Sensor Module Pinout
This Module has 4 pins:
- VCC: Module power supply – 3.3V to 5V
- GND: Ground
- D0: Digital Output
- A0: Analog Output
Code
Upload the following code to your Arduino
|
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 |
/* SW-18010P-Vibration-Sensor-Module */ #define Dig_pin 7 int Dig_out = LOW; int Ana_out = 0; void setup() { Serial.begin(9600); } void loop() { Dig_out = digitalRead(Dig_pin); Ana_out = analogRead(A0); Serial.print("Anaolog : "); Serial.print(Ana_out); Serial.print(" Digital :"); Serial.println(Dig_out); delay(500); } |
Reviews
There are no reviews yet.